Chapter 1 AUTOMOTIVE HAND TOOLS MCQs 11 min Score: 0 Attempted: 0/11 Subscribe 1. Screw driver’s size is determined by (A) Length of shank (B) Both are correct (C) Width of blade (D) Both are incorrectShow All Answers 2. Following statement about hammer is correct. (A) Available by length (B) Ball peen is used for riveting (C) For full blow grip it near hammer (D) All are trueShow All Answers 3. To remove broken bolt following plier is used. (A) Combination plier (B) Curved long nose (C) Crimping plier (D) Vise-gripShow All Answers 4. Following is true about spanners. (A) In ring spanner 15° hand clearance is given (B) Open spanner has different size on ends (C) Pushing spanner is better than pulling (D) All are correctShow All Answers 5. This socket box item can work on angle. (A) Speed handle (B) Universal joint (C) Ratchet handle (D) T-handleShow All Answers 6. Following is true about socket. (A) 12 sided socket has good grip than 6 side (B) Drive sizes are 1/4, 3/8, or 1/2 inch (C) Normal size of socket is 1 mm to 64 mm (D) All are correctShow All Answers 7. Following torque wrench gives option to set the torque. (A) Deflecting beam type (B) Dial indicator type (C) Micrometer type (D) None of theseShow All Answers 8. Following puller is used for brake drum remover. (A) Sliding hammer type (B) Pressure screw type (C) Combination type (D) Magnet pullerShow All Answers 9. To prevent leak at the end of tube, we will use. (A) Bender (B) Flaring (C) Reamer (D) CutterShow All Answers 10. To install piston assembly, we will require. (A) Valve spring compressor (B) Piston ring compressor (C) Piston ring expander (D) Ridge cutterShow All Answers 11. To remove a pin from a hole, this punch will be used. (A) Central punch (B) Hollow punch (C) Pin punch (D) Drift punchShow All Answers
