1. Screw driver’s size is determined by
(A) Length of shank
(B) Both are correct
(C) Width of blade
(D) Both are incorrect
2. Following statement about hammer is correct.
(A) Available by length
(B) Ball peen is used for riveting
(C) For full blow grip it near hammer
(D) All are true
3. To remove broken bolt following plier is used.
(A) Combination plier
(B) Curved long nose
(C) Crimping plier
(D) Vise-grip
4. Following is true about spanners.
(A) In ring spanner 15° hand clearance is given
(B) Open spanner has different size on ends
(C) Pushing spanner is better than pulling
(D) All are correct
5. This socket box item can work on angle.
(A) Speed handle
(B) Universal joint
(C) Ratchet handle
(D) T-handle
6. Following is true about socket.
(A) 12 sided socket has good grip than 6 side
(B) Drive sizes are 1/4, 3/8, or 1/2 inch
(C) Normal size of socket is 1 mm to 64 mm
(D) All are correct
7. Following torque wrench gives option to set the torque.
(A) Deflecting beam type
(B) Dial indicator type
(C) Micrometer type
(D) None of these
8. Following puller is used for brake drum remover.
(A) Sliding hammer type
(B) Pressure screw type
(C) Combination type
(D) Magnet puller
9. To prevent leak at the end of tube, we will use.
(A) Bender
(B) Flaring
(C) Reamer
(D) Cutter
10. To install piston assembly, we will require.
(A) Valve spring compressor
(B) Piston ring compressor
(C) Piston ring expander
(D) Ridge cutter
11. To remove a pin from a hole, this punch will be used.
(A) Central punch
(B) Hollow punch
(C) Pin punch
(D) Drift punch