SHAPER WORK MCQs 10 min Score: 0 Attempted: 0/10 Subscribe 1. Shaper machine do not perform following operation. (A) Horizontal, vertical planes (B) Drilling (C) Contoured surface (D) Inclined planes 2. Ram moves back and forth on which part. (A) Cross rail (B) Guide rails (C) Tool head (D) Apron 3. Which part lifts shaper tool on return stroke. (A) Tool post (B) Swivel head (C) Tool lifter (D) Apron 4. Which part selects the amount of feed. (A) Gear shifter lever (B) Power cross feed selector (C) Tool lifter (D) Feed screw crank 5. Following is true about backward stroke. (A) It is return stroke (B) It is cutting stroke (C) It is greater than cutting stroke (D) None of them 6. Roughing tool is used when: (A) Machining the job right to the left (B) High quality finish required (C) To remove good amount of material (D) Slots are cut 7. V-shaped grooves are obtained by: (A) T-slot cutting tool (B) Form tool (C) Goose neck tool (D) Left hand tool 8. Generally shapers have linkage using: (A) 220° for cutting stroke (B) 140° for return stroke (C) All are correct (D) 3:2 ratio 9. A 16" shaper may have speeds up to (strokes/minute). (A) 27 to 150 (B) 5 to 22 (C) 10 to 90 (D) None of them 10. On shaper feeds for rough range up to (per stroke). (A) 0.015" (B) 0.001" (C) 0.100" (D) 0.030"
