1. Bearings are not used in:
(A) Engine
(B) Battery
(C) Drive line
(D) Steering
2. Bearing loads are computed by:
(A) Weight
(B) Movement of load
(C) Both are incorrect
(D) Both are correct
3. Bearings are used to reduce:
(A) All are correct
(B) Heat
(C) Wear of components
(D) Friction
4. Radial load is produced by a component pressing at ______ degree to the side of bearing:
(A) 90°
(B) 180°
(C) 270°
(D) 360°
5. Axial load is produced by a component pushing directly against bearing from:
(A) Both are correct
(B) Outside in
(C) Inside out
(D) Both are wrong
6. Following is rolling element in an anti-friction bearing:
(A) Outer cup (race)
(B) Tapered roller
(C) Inner race
(D) Cage
7. Following part of insert bearing keeps it in place:
(A) Oil groove
(B) Flange
(C) Locating tab
(D) None of these
8. Bearing material can be:
(A) Babbitt
(B) Copper lead alloy
(C) Aluminum
(D) All are correct
9. To fit the insert tightly within housing, following is used:
(A) Bearing spread
(B) Dowel pin
(C) Crush
(D) Locating tab